UniRac SunFrame 192" Capstrip > 1 Unit
Finish: Clear Anodized
Manufacturer Part Number: 202002C
Capstrip fits modules size D (38 - 40 mm / 1.50 - 1.57 in. thick). For use with Unirac SunFrame. Requires 3/4" cap strip screw.
- Superior Aesthetics:Visible components match clear or dark module frames.
- Optimized module performace, system spacing allows convection cooling.
- Ease of Installation: Minimized penetration with longer attachment spans than comparable products.
- Complete technical Support: Installation and code compliance documentation
|A||24 - 26 mm|
0.94 - 1.02 in
B||30 - 32 mm|
1.18 - 1.26 in
C ||34 - 36 mm|
1.34 - 1.42 in
D ||38 - 40 mm|
1.50 - 1.57 in
K ||39 - 41 mm|
1.54 - 1.61 in
J ||41 - 43 mm|
1.61 - 1.69 in
F ||45 - 47 mm|
1.77 - 1.85 in
M ||47 - 49 mm|
1.85 - 1.93 in
E ||50 - 52 mm|
1.97 - 2.05 in
N ||57 - 59 mm|
2.24 - 2.32 in
H & L||Sanyo lipped modules||Not Available|
G ||Sharp lipped modules||Not Available|
A Stunning Environmental Statement
Unirac’s SunFrame system leads the PV market with it's superior aesthetics. It's sleek design is engineered to sit low to the roof without gaps and implements shared rails for the best value.
Low and clean lines give SunFrame two advantages. The finished array stands off the roof just enough for cooling airflow to optimize module performance while all modules sit in low, gap-free rows without protrusions from the sides of the array.
Attachments and Flashing Systems:
- Cap Strips
- Standoffs & Flashings
- L-Feet Adjusting Sliders
- End Caps
Low and clean lines give SunFrame two advantages. The finished
array stands off the roof just enough for cooling airflow to optimize
module performance while all modules sit in low, gap-free rows without
protrusions from the sides of the array.