ProSolar Roof Trac Tilt Up Kit
3 legs. This is a pack of 3 tilt up kits. Single tilt up kits are also available.
Model |
A-TU24-3 |
Manufacturer |
ProSolar |
Quantity |
3 |
Contents
Each kit contains the following parts:
- 3—1" x 1" x 24" square tube, drilled on each end
- 6—Lower (unthreaded) tilt-up brackets—pre tapped
- 3—Upper (threaded) tilt-up brackets
- 3—Upper (hollow) lower hinge brackets
- 12—5/16" x 2" Stainless Steel socket cap screws
- 6—3/8" x 3/4" Stainless Steel hex bolts
- 12—3/8" Stainless Steel lock washers
Detailed Description
Used with patented RoofTrac support rail for tilts up to approx. 28 degrees. The Roof Trac Tilt Up kit is a residential tilt up accessory for the Roof Trac solar PV mounting system. The Tilt up kit integrates with both the Tile Trac and the Fast Jack attachment methods.
- Tested for major module lines up to 50 lb/ft2 (125 mph wind equivalent - relative to 2006 IBC/2007 CBC defined wind load values)
- Stainless Steel and aluminum design to help prevent corrosion (rust) and maintain high strength